If the system uses 4 wire volume override, make sure that the 3 wires local volume control box is empty. The Select All button makes it possible to enable supervision of all emergency trigger inputs that are connected to the selected unit. Rename message, step 2 3 Enter the new name of the message in the text box e. It provides information necessary. Edit messages Each message can have up to 8 components
| Uploader: | Gardakasa |
| Date Added: | 17 October 2007 |
| File Size: | 26.33 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 77866 |
| Price: | Free* [*Free Regsitration Required] |
Plena Voice Alarm System. Software Manual Configuration Software
This Application Note describes how a firmware update. Instead of assigning a wave file that contains the word one to the Variant, a wave file containing the word pleha must be assigned to the Variant see figure 6.
This quick start guide will help you become familiar with our DVR in a very short time. Make sure that the PC is working correctly and free of viruses before installing the software.
To each of the positions a wave file can be assigned orange. The file can be used either as an ssytem file or a back-up file when the configuration is complete. Use this window to manage messages Action programming The Action programming button opens the Action programming window see chapter 7.
Plena Voice Alarm System Firmware update 1. August Copyright Nortel Networks More information. A window similar to the one in figure 5. To check that you have the latest version, go More information. In the default configuration the spare amplifier supervision is ON, if no spare amplifier is connected, the system will not have BGM Make a backup of the file Proceed as follows: Speech that contains the number of the floor.
The message is based on the template that was created in section The template components are: Priorities 17, 18 and 19 can be set. The letters are case donfiguration.
Plena Voice Alarm System Download - Plena-vasexe
Commercials and push the OK button. If Momentary is selected, the trigger is active until the signal stops. With the configuration software, configuratuon different mergeable message templates can be created.
This message sounds before the message that is programmed for the trigger input received. Copyright All Rights Reserved Copyright The use, disclosure, modification, transfer, or transmittal of this configurahion for any purpose, in any form, or by any means, without the written permission of the copyright More information.
Example, step 5 6 Click the Save button to save the changes. August Copyright Nortel Networks Example, step 8 9 Click the Save button to save the changes. It provides information necessary More information. The spoken part of the merged message is: Variants cannot be repeated.
By default, this box contains a checkmark therefore if a loudspeaker line has a short circuit, the line is isolated.
Plena Voice Alarm System. Software Manual Configuration Software - PDF
The Select All button makes it possible to enable supervision of all emergency trigger inputs that are connected to the selected unit. For example, in a hotel, configuratin following zones could be added to the zone group Floors: Example, step 2 3 Enter the name of the new message for example, Floor 1 evacuation and click the OK button.
EMG trigger Individual message trigger settings Proceed as follows for each emergency trigger input: For Amplifier select the amplifier.
The window disappears and the new name of the zone group is displayed in the Zones window see figure 4. No part of this document may be copied or reproduced in any form or by any alam without the. The total file size of the wave files must be less than 16 MB Mergeable messages A special type of message is a mergeable message see section for an example.
The remaining zone selection button on the systeem station selects all zones that are assigned to the other zones selection buttons.
No comments:
Post a Comment